What is the Force-H2 (โมดูล FH9637M + คอนโทรลเลอร์ FC0500M-40S)?
- System capacity: 7.10 / 10.65 / 14.20 kWh with 2 / 3 / 4 stacked modules of 3.552 kWh each
- System voltage: 192 / 288 / 384 VDC — high-voltage architecture with far lower current than 48 V at equal power
- Current: 18.5 A working (7.4 A standard), 40 A peak, 96% round-trip efficiency
- IP55 rating: dust protected and resistant to water jets, allowing more installation flexibility than IP20 rack batteries
- Life and warranty: 5,000 cycles, 15+ year design life, 10-year warranty at no less than 60% remaining capacity
The Pylontech Force H2 is a floor-standing high-voltage lithium battery system built by stacking 3.552 kWh modules — two, three or four of them for 7.10, 10.65 or 14.20 kWh. The key difference from 48 V products like the US5000 is system voltage: 192–384 VDC means far lower current at the same power, so cabling is smaller, losses are lower and heat build-up is reduced. It pairs with high-voltage hybrid inverters such as the Deye SG01HP3 family and Solis H-series.
High-voltage versus 48 V batteries — which should you choose?
The difference comes down to basic electrical arithmetic: power equals voltage times current. Delivering 10,000 W from a 48 V battery requires roughly 200 A, which demands heavy copper and generates significant heat. At 384 V the same power needs only about 26 A, so cable sizes drop sharply, installation cost falls, and resistive losses — which scale with the square of current — fall further still. The trade-off is that high-voltage batteries must be matched to inverters designed for that range. Per the manufacturer's documentation, the Force H2 works with Deye/Sunsynk SUN-5~25K-SG01HP3-EU/AU and SUN-29.9~50K-SG01HP3-EU/AU over CAN, and with Solis RHI-3P-HVES-5G and S6-EH3P series units — with specified firmware versions on both the inverter and the battery controller. The other practical difference from 48 V rack products is the IP55 rating, which allows more installation flexibility, though in Phuket we still specify a sheltered, ventilated location.
Highlights from the datasheet
- 192–384 VDC architecture: much lower system current than 48 V, meaning thinner cable, lower losses and less heat
- 2–4 stackable modules: choose 7.10, 10.65 or 14.20 kWh, with room to add modules later
- IP55 protection: dust protected and water-jet resistant, more flexible on siting than IP20 rack batteries
- 96% round-trip efficiency: little energy lost between charging and discharging
- 95% depth of discharge: nearly all purchased capacity is usable, unlike lead-acid where roughly half is practical
- 5,000 cycles, 15+ year design life: matched to daily charge-discharge duty across a solar system's lifetime
- 10-year warranty: no less than 60% of nominal energy remaining, per the Force H family warranty document
Key specifications (Force-H2 (โมดูล FH9637M + คอนโทรลเลอร์ FC0500M-40S))
| Specification | Datasheet value |
|---|---|
| Battery System Capacity | 7.10 / 10.65 / 14.20 kWh (ต่อซ้อน 2 / 3 / 4 โมดูล) |
| Battery Module Capacity | 3.552 kWh (โมดูล FH9637M, 96 VDC, 37 Ah) |
| Depth of Discharge (DoD) | 95 % |
| Usable Capacity | เอกสารผู้ผลิตไม่ได้ระบุเป็น kWh โดยตรง ระบุเพียงค่า DoD 95% |
| Cell Technology | Li-ion (LFP / LiFePO4) — 30 เซลล์อนุกรมต่อโมดูล เซลล์ละ 3.2 V 37 Ah |
| Battery System Voltage | 192 / 288 / 384 VDC (ตามจำนวนโมดูล 2 / 3 / 4) |
| Charge/Discharge Current (Normal) | 18.5 A (ค่ามาตรฐาน 7.4 A) |
| Max. Charge/Discharge Current @15s | 40 A (พิกัดลัดวงจร < 4,000 A) |
| Efficiency | 96 % |
| Operation Cycle Life (Module) | 5,000 รอบ (อายุใช้งาน 15 ปีขึ้นไป) |
| Dimensions (W×D×H) | 450 × 296 × 822 มม. (2 โมดูล) / 450 × 296 × 1,118 มม. (3 โมดูล) / 450 × 296 × 1,414 มม. (4 โมดูล) |
| Weight | 82 / 117 / 152 กก. (2 / 3 / 4 โมดูล) |
| Protection Class | IP55 |
| Communication | CANBUS / Modbus RTU |
| Compatible Inverters (Pylontech Compatibility List Ver.2.35) | Deye/Sunsynk SUN-5~25K-SG01HP3-EU/AU และ SUN-29.9~50K-SG01HP3-EU/AU (CAN, เฟิร์มแวร์อินเวอร์เตอร์ 2001-X018 และเฟิร์มแวร์ Battery Controller ของ Force-H1/H2 ต้องเป็น V1.7 ขึ้นไป) · Solis RHI-3P-HVES-5G series, S6-EH3P(5-10)K-H-EU, S6-EH1P(3.8-11.4)K-H-US, S6-EH3P(12-20)K-H, S6-EH3P(29.9-50)K-H (CAN) · เอกสารฉบับนี้ไม่มี Growatt ในตารางระบบแรงดันสูง |
| Warranty | 10 ปี ความจุคงเหลือไม่น้อยกว่า 60% ของ Nominal Energy (ตามเอกสาร Consumer Warranty ตระกูล Force H ฉบับ EU/UK) |
Note: every figure above comes straight from the Pylon Technologies Co., Ltd. datasheet. Actual system design (strings per MPPT, cable sizing, breakers) must be calculated for each site.
Why this model suits Phuket
- Villas with long cable runs: high-voltage architecture reduces conductor size and losses, which matters when the battery sits far from the inverter
- IP55 gives siting flexibility: a covered garage or sheltered semi-open area is workable, though we still specify shade and protection from driven rain
- Three-phase homes and businesses: pairs with three-phase high-voltage hybrids like the Deye SG01HP3, a combination we install regularly on villa and commercial work
- Year-round humidity: requires a ventilated location and periodic terminal inspection, which we include in our maintenance plans
Who it suits
- Large homes and pool villas: needing 7–14 kWh alongside a three-phase supply
- Systems using high-voltage hybrid inverters: Deye SG01HP3 or Solis S6-EH3P series
- Installations with long battery-to-inverter runs: where high voltage reduces cable cost and losses
- Small to medium businesses: clinics, restaurants or offices backing up several kilowatts
- Projects wanting a longer documented warranty: 10 years at 60% remaining capacity
Summary
The Pylontech Force H2 is a floor-standing high-voltage battery scalable from 7.10 to 14.20 kWh, suited to larger Phuket homes, pool villas and businesses running high-voltage hybrid inverters. Lower system current means smaller cable and lower losses, IP55 gives more siting flexibility than rack batteries, and the warranty runs ten years. The caveat is compatibility: it must be matched to an inverter designed for this voltage range, with firmware versions verified before ordering.
See other models from this brand on the Pylontech overview, or browse all the equipment we install.
Download the datasheet (PDF) — full manufacturer specification sheet